SPEED MASTER witY"'" • • Activation - Before starting Bike Watch Please remove the protective foil from the display when you use the s
For your reference, you can fOllowing methods to take different measurement: STANDARD MEASUREMENT: A-A-A lP aa --... 0 ... _STA_RT ... ~\ DD'D
HEART RATE MODE Press the 0 button until you are in lhe heart rate mode, displayed by "HRM". ---~ HRM By pressing the C button in the heart
Memory Press the C button in the heart rate mode until MEMORY is displayed. The saved heart rate data is shown in the lower segment of the display, th
Training Zone Alarm Keep the C button pressed with the display of the upper and lower limits. Alarm symbol-I} appears = Training zone alarm activated
BMI (Body Mass Index) Age BMI normal (years) value (kgfm2) 19-24 19 - 24 20 _ 25 35-44 21 -26 45-54 22 -27 ---@ ... T 16~iit B: 2222-55-54 23 -
Fitness Level Press the C button in the heart rate mode until FITNESS LEVEL is displayed. Press the A button immediately after the training (with appl
Dal/y Distance Press the C button in the bike mode until DISTANCE is displayed. The covered distance is shown in the lower segment of the display (wit
Calories, Fat and BMI Press the C button in the bike mode until CALORIES is displayed. In the lower segment of the display calories, fat and BMI are
Scan function (SCAN) Press the C button in the bike mode until SCAN is displayed, The trip time, trip distance, average speed, maximum speed, total di
Setting of the total distance as well as calibration of the speed for walking and running. Note: It does not matter if you want to only walk or run, u
INTRODUCTION WARNING: Always consult your physician before starting a fitness programme. Apulse computer is nol a medical device. It is a training too
It is important that you also perfonn the calibration for walking, as described in the following section: • You can choose bet\veen YES and NO with th
Calories, Fat and BMf Press the C button in the heart rate mode until CALOR IE is displayed. In the lower segment of the display calories, fat and 8M
Timer Press the C butlon in the pedometer mode until TIMER is displayed. The timer is shown in the lower segment of the display. in the middle the cur
TROUBLESHOOTING Why is the displayed covered distance incorrect? Have you performed a calibration? For optimum results the calibration has to be perfo
FEATURES If necessary, you can consuilihe table on the gift box. SPEED MASTER • Digital motion sensor for speed detection • Current speed • Exercise t
WEARING THE TRANSMITTER BELT Adjust the elastic belt so that it fits f:8' lightly around your Chest just belOW' the pectoral muscles. Moist
TRANSMITTER INSTALLATION Clamp the magnet on the spoke of front wheel with the screw provided and attach the transmitter to the left fori< by using
Function Button/Modes/Settings Function Buttons of the Speed Master Watch LIGHT Button (B) '----. STiSP/SET Button (A) Main Function Mode MODE Bu
• Press the C button to reset the seconds to zero. Confirm your selection with the A button, the minutes blink. Note: You can use the fast forward fu
Bell symbol " displayed = hourly alarm on Bell symbol not displayed = hourly alarm off Now press the D button, all settings are saved and the se
STOPWATCH MODE Press the 0 button until you reach the stopwatch mode, shown by "CHRONO". In stopwatch mode you can choose between the sub f
Comments to this Manuals