Pyle PHRM24 Instruction Manual Page 1

Features:- Time & Date- Daily Alarm- Jumbo Digit LCD- Dual Purpose 3D Sensor From Germany (Walking or Running)- Intelligent Step Filter Function-

Chronograph resume again Target time after 3min 21sTarget time enabledTarget time disabled Target time enabled orTarget time disabled or10

Calibration1. Press the MODE/SET button until you have reached the calibration mode which should display "CAL'.2. To begin calibration, p

Note:- During the process of calibration, press and hold the MODE/SET button to quit calibration which will be indicated by 2 vibrations accompanied

8. Press MODE/SET button to confirm your option and continue to set the zonal operation alert.9. Toggle between on and off using the START/LAP/RESET b

Note:- Any changes or alterations made to target hour and minute will automatically enable the target time alert function.- If no keys are pressed or

PC- Link Upload1. Install the PC-Link interface program.2. Plug the USB into the computer.3. Within the interface program, locate the upload button an

16INSTALLING THE BATTERYThe Watch uses 2 pieces CR 2032 batteries (one each for watch and heart rate belt ).Use only the recommended batteries.NOTE :

17 Dlagram 1Dlagram 2Heart Rate BeltHold the Heart Rate Belt firmly. Insert a coin into the slit of the compartment lid and turn itclockwise. The lid

18SPECIFICATIONSTime Format Year, month, date, day, hour, minute, second, am/pm 12/2

23D SENSOR FROM GERMANY-MEASURES YOUR MOVEMENT ACCURATELY-The 3D technology in the accelerator is an accelerometer Sensor to measure acceleration in w

2 2 3 4 5 5 6 6 71112121415151618183Getting Start...

4gFAT - Unit of Fat BurntNOTE- When you walk or run for around 10 seconds, the unit sensor will pick this up and a display showing current pace for t

TIME/DATE MODEALARM MODE CHRONOGRAPH MODECALIBRATION MODEMEMORY RECALL MODE5TIME/DATE MODE – ALARM MODE – CHRONOGRAPH MO

Note:- At anytime to exit the time and date setting mode, press and hold MODE/SET button for 3 seconds.Alarm Mode1. Press the MODE/SET button until y

Note:- Any changes made in the alarm mode will automatically enable the alarm.- At anytime to exit the alarm setting mode, press and hold MODE/SET but

After 3 secondsChronograph Count down for 5sTarget time disabledTarget time enabledor8

After 5sTarget time enabledAfter 2 minute15 secondsTarget time disabledTarget time enabledLap 1 Record Created Target time stoporTarget time disabledT